This demonstration shows how to connect a fan to the Zilog RF MotherBoard relay and how to control it. Positive wire of fan is connected to pin1 of three pin terminal block J6. Negative wire of fan is connected to the GND pin adjacent to pin1 of the three pin terminal block J6. Please note that 6V is connected to pin2 of the three pin terminal block J6. LED8 turns on when the Relay K1 is turned on. LED8 is turned off when Relay K1 is turned off.
The demo shows how to send text messages from one Zilog RF MotherBoard Node to another Zilog RF MotherBoard Node and display it on the LCD screen. The demo also shows how to select from the various text messages that are available and send it to another Zilog RF Motherboard Node.
This demo shows how to control the LED1 and/or Relay on Node 2 from a PC Internet Explorer webpage via Node 1 (the Master). You must follow the setup in the demo "MBB Ethernet setup" first before doing this demo to setup the default gateway address. The PC must have JAVA loaded already. The demo shows how clicking the diode button will turn on/off the LED1 diode on the Node 2 MotherBoard. The demo also shows how clicking the relay button will turn on/off the relay on the Node 2 MotherBoard ...
This shows how to set up an Ethernet Connection to Zilog RF MotherBoard Demo from a local PC. The PC is connected to the Zilog RF MotherBoard with a CAT 5E Ethernet Patch Cable. LAN Settings page in the Internet Options on the PC under Connections tab must have the Automatically Detect Settings checked only. The ethernet cable in this demo is connected to Node 1 the Master but it can be connect to another slave. Please note that since the MotherBoard does not detect a network connection then ...
This demonstration shows powering up with 2.6v BAT_POS power supply then powering up v3v3 power supply and disconnecting the v3v3 before 5 seconds. The current drain is 358ua on the BAT_POS power supply. Later the v3v3 power supply is re-connected to 3.3v. After waiting more than 5seconds, the 3.3v is removed from the v3v3 and only 8ua of current drain is shown on the BAT_POS power supply.
