Lidmotor Videos

This device turns 1.5 volts into many thousands. It is a combination of the 'Jeanna's light' circuit and a simple car ignition coil circuit. The project was inspired by "Kooler's" ideas and Tesla coil designs. The Jeanna big toroid Joule Thief circuit provides the primary voltage bump. That is then pulsed with a capacitor and spark gap arrangement into a 12 volt car ignition coil. This raises the voltage high enough to jump a 1" spark gap (in pulses) and fires a small xenon flash bulb ...

Tags: Joule Theif Tesla coil electronics energy

This is the second video on my 'Light Multiplier' showing the amp draw with and without the oscillator driving the neo magnet rotor. It is of interest because the amp draw is actually less when the oscillator is pulling the rotor load. The spinning magnet, however, generates electricity in a second coil ('Maggie') and lights up two more leds.

Tags: Pulse Motor Joule Thief Led lighting Energy Electronics One magnet no bearing Bedini.

This is a simple circuit neo magnet spinner that is like a Joule Thief but made out of a AC fan motor coil. The 1.5 volt device self-oscillates once started, illuminates an LED. and drives a neo magnet on a mirror. The spinning neo then lights up 'Maggie's eyes through an induction link. One AA battery drives the circuit and drains at about 20 ma. Three leds are illuninated instead of one. The circuit runs at about 5khz and the wave form is "h" shaped.

Tags: Joule Thief Bedini SSG Pulse motor LED lighting Energy Electronics

This is a standard Joule Thief circuit with a tunable inductor coil. The simple one transistor circuit is powered off one 1.5 volt AA battery and is driving multiple leds in two locations. The coil is hollow and a ferrite slug is used to adjust it's three windings into resonance. A potentiometer at the transistor base is also used to fine tune the circuit. The 27 leds are on a Dr. Stiffler SEC tower and are-- IN SERIES! The one LED on the board is in the standard location off the collector ...

Tags: Joule Thief Energy Electronics Led lighting

This is a modified Joule Thief circuit combined with Dr. Stiffler's SEC exciter towers. The video shows one wire energy transmission happening and illuminating 27 leds in series from one thin soild core wire at a distance of 4 ft. An LED and a 110volt neon are also shown lighting up in the excited environment around the towers. No circuit diagram is available for this because the circuit is still being developed.

Tags: SEC exciter Joule Thief Energy Electronics Tesla

This is Mart Hale's great idea for a super simple rotor on a Bedini motor. It is just a Neo ring magnet hung on a plastic coated heavy gauge wire. The diametrically magnetized (N&S on sides) rotor spins up infront of the drive coil with just the wire to support it ---and keep it from running away. I am using it on 'Turner' in this video and he is configured to run on just a simple reed switch circuit. A little light lubricant (I used 3-in-1 oil) keeps the rotor spinning freely. The setup ...

Tags: Pulse Motor Bedini SSG One Magnet No Bearing Bedini Energy Electronics.

This is Jeanna's Light installed in a wooden box. The video shows how the circuit pieces fit into the box and the amount of light that the device produces with one 10 watt CFL or two super bright white leds. My excellent assistant "Dewey" helps out in this video.

Tags: Joule Thief Energy CFL lighting LED lighting Electronics

This is a modified version of Jeanna's Joule Thief FL driver circuit using a big 31/4" toroid coil. The circuit is running on one AA 1.5 volt battery. A modified 10 watt CFL bulb is being illuminated. The circuit shown in the video has an error in it. There is no connection between the transistor base and the circuit negative rail. A 100pf capacitor can be placed there and Jeanna used one. I just eliminated it and got the circuit to run with one less part. Information on her circuit can be ...

Tags: Joule Thief CFL Lighting Electronics Energy

This is my reed switch pulse driver "Turner" shown driving several types of magnet tops. The Saturn Magnet is shown driving " Maggie" my little remote generator. Two other "tops" are shown being run at high RPM with just the reed switch turning the drive coil on and off at a high rate. A small radio is used to be able to hear the speed.

Tags: Pulse motor One magnet no bearing Bedini Electronics Energy

I named my new pulse motor "TURNER". He has kind of a grumpy expression because he has to do work turning things while his friend "Maggie" enjoys life with all the free energy that he gives her. Life ain't fair.

Tags: Pulse motor Magnets Energy Electronics LED lighting